Quote:
Originally Posted by TinCanAlley
Should I put the CRT on the Tester again? I am not sure I did it correctly the first time because I wasn't sure what the manual meant by (one divider on the meter). It's a B&K 470.
|
If you can get a decently bright raster, I doubt the CRT is at fault. But you should learn how to use the tester to if you think you got it figured out, by all means check it. those Zenith CRTs of the era were quite good (long lasting).
you should not have to turn up the screen drives very far to get a bright raster (no signal just snow). If you turn them up and get a normal white brightness raster, then switch to service mode and DO NOT see the horz lines (RGB they will be faint but should be there, close together if not on top of each other), then there is something wrong that should be corrected before the jail bars.