Thread: B&W TV Focusing
View Single Post
  #8  
Old 08-27-2013, 09:32 AM
old_tv_nut's Avatar
old_tv_nut old_tv_nut is offline
See yourself on Color TV!
 
Join Date: Jul 2004
Location: Rancho Sahuarita
Posts: 7,815
Quote:
Originally Posted by VintagePC View Post
Well, this thread just got a whole lot more interesting. Now that you mention it, there _does_ seem to be a lack of scan line density that doesn't seem to match up to the 525 standard.

I'll double-check tonight... Am I correct in guessing a problem in the drive circuitry could cause this since the interlacing means you need a pair of sweep sawtooths now instead of a single identical one that repeats?

Sounds like a bear to locate and troubleshoot though as it would involve probing around with a scope...
Interlacing happens automatically with a single continuous horizontal sawtooth and single continuous vertical sawtooth because the ratio of 15750 to 60 is 262.5. Line pairing occurs when some horizontal energy gets into the vertical sync and causes every field to start on a whole line instead of alternating between a half line and a whole line.

You can check for this problem by rotating the vertical hold control very slowly and seeing the line pairing come and go.

Fixing this problem (other than tweaking the vertical hold carefully) can be nearly impossible if it is due to a particular chassis design causing horizontal sweep currents getting into the vertical sync. It can be affected by wire dress, ground points, etc.
Reply With Quote