|
i just noticed my meter has AC ma and DC ma so i could measure the ma .... is it between the resistor and pin or the resistor to the ground or across the resistor ? this 100 ohm resistor is 120 ohms and replacement ( i put the 120 ohm by accident instead of the 100 ohm ) , its a power resistor , i could put a 100 ohm there or put a higher like 200 ohms to reduce the flow ?
also do i measure the ma at the horz drive or at the resistor? i'm just a little confused i never measured ma before or is what is on my meter not what i need to measure ?.
mike
Last edited by kramden66; 07-31-2013 at 12:37 AM.
|