View Single Post
  #20  
Old 07-30-2013, 07:24 PM
cwmoser's Avatar
cwmoser cwmoser is offline
VideoKarma Member
 
Join Date: Dec 2009
Posts: 552
Quote:
Originally Posted by kramden66 View Post
the fly - it gets hot , you can move the coating on it after running for 15 to 20 minutes , so either its being overdriven or its on its way out, it does show 12kv on the anode whick i think is normal for a 16ep4

Make sure you have both 6BQ6 Hor. Output tubes and they check OK.
There is a common 100 ohm Cathode Resistor (R83). I read that the
cathode current should be less than 100ma. Instead of putting an
amp meter in series, measure R83 to see how close to 100 ohms it is.
Then power the set and measure the voltage across R83. Then
calculate the current. I understand too much current in R83 will overdrive
the Flyback and cause it to heat up.

There is an adjustment that affects this current - Hor Drive.
Adjust for best picture and less than 100ma.


Carl
__________________
CW
1950 Zenith Porthole - "Lincoln"
Reply With Quote
Audiokarma