|
The hum problem was two bad 6AU6s in the IF chain. There still was hum
in the vertical sweep from inadequate filtering in the B- supply. The
original "100 uF" filter cap measured 160 uF, the new one, right at 100 uF,
so I paralleled it with another 100uF, and it is much improved.
Also ... this set appears to be a slight hybrid of the Rider's (1948) and
Sam's (1949) designs. In particular, the vertical sweep output feedback is
Rider's while the rest is mostly Sam's. Since the (dogbone ceramic) capacitors in this
circuit were very low (.001 uF rather than .0015) I tried the Sam's circuit
and it works much better. The previous owner replaced the 3000 kV .005 uF paper
vertical sweep with .0033 uF ceramics, which is too low. .005 uF is too low too,
so I'm ordering up 4 .01 uF 6 kV ceramics to get .02 uF. These are not cheap.
Other than the vertical sweep problems, it now generates a very nice picture.
I'm going to try an alignment using my proposed non-sweep method:
using Comcast digital as a source, a spectrum analyzer to look at the
output, and a nice synthesizer as marker generator. It may not need alignment
since it seems to work OK.
Doug McDonald
|