|
You may remember that I said your scope most likely will not be able to show a wave form with a DC offset applied to it. Your clock most likely relies on a dc offset to put that picture on the scope. Because you can not get a display with dc offset, the clock may move around the screen. In a way, you are seeing what some people here complain about when a tv does not have a dc restoration circuit for picture tube bias.......
The ground form the clock can go to any ground post you see on the front of the scope. Your X and Y go to the vert, and Horiz. input at top right and left on the scope. Most likely not the direct input since its a 15v and 30v input, your clock is most likely less, so use one of the other low voltage scales and that includes access to the amplitude adjustments on the scope, its in the instructions. And also when the sync is set to ext. you have access to a Z axis blanking of the crt, that is pretty special for stuff like turning the scope into a clock because you can blank the retrace lines..... Read that instruction book a few times.... Your clock also has info on using the z axis its in the faq's
Now if the cycle time of the clock is fast enough, and it sounds like it is.... then the 505 will not be such a factor in not supporting dc offset because the clock cycles the screen so fast....
Since you already have it you gotta try it.
You can look into lowering the baud rate if you need to for the slower scope you have....
__________________
Yes you can call me "Squirrel boy"
Last edited by Username1; 05-16-2013 at 01:55 PM.
|