I got back under the chassis tonight and got R147 down to 3300 ohms. I can't quite tell if it made the problem less noticeable. I reported earlier that the controls on the set didn't affect the problem, but I did figure out that the higher I set my picture control the less noticeable the symptoms becomes. When the picture control turned all the way up the symptom is much reduced, although definitely still there. The overall picture also lacks good contrast which could point to that area. I've started to do some resistor checking in the picture IF section, but nothing is standing out yet. I feel like the picture control just isn't adjusting the signal like it should. As Phil stated before:
Quote:
Originally Posted by Phil Nelson
|
My picture control at one end is 0 signal and the other end seems like it should "go further".