|
Hi All;
Thank You both for your great replys.. I had for the most part only planned to use the 10:1 probes.. And If I remember right Both scopes are 100 MHZ scopes anyway.. So bandwidth is no problem..
As far as the Hight Voltage probes, Yea, for making measurement, the VTVM or digital voltmeter would be fine with the correct Divider probe.. Which I am still asking are they arround at a reasonable price ??
But, my main reason for asking about using with a scope, was to look at waveforms on all those Very High Voltage Tubes, and asscoiated parts.. Damper Tube, Horizontal Output Tube, Width and Linerity pots or coils, etc... A meter will give me a voltage, but not a waveform.. Especially on my 8T243 Where Everything is Greatly out of "Wack".. Which is part of the reason "Why" I got the 630TS, In many areas, they have either the same part or are close, same with the circuits many of them are the same or similiar.. So, I can take some part out of the 8T243 and IF It would need to be checked or adjusted I would put it in the 630TS and adjust it and then put it back in the 8T243.. Working on a section at a time, Horizontal, Vertical, Sync, etc.. I realize that can only be done once I have the 630 working 100%..
THANK YOU Marty
|