Quote:
Originally Posted by Chip Chester
On the gear detail...
I have a buddy with a desktop laser cutter. He can cut wood, phenolic, and non-PVC plastic (I think), but no metal. Runs of a CAD/CAM file. It's in a community/membership-based shop in Columbus. If the teeth are not too fine, I believe he could cut one of those in pretty short order.
I realize you've engineered a good solution, so you're no longer needing a replacement gear. But is this a common need out is resto-land? And do you think phenolic would hold up to the tuning duties?
(There are many of these community shops out there, too.)
Chip
|
From what I read most of these potmetal gears just crumble. I have no idea how many of these are still in the "wild" or the demand for such pieces. The small gear on the other end of the knob shaft was not pot metal, but some kind of fiber. I Have a 3d printer and I was going to try to print one, but it would have had to be made in 4 pieces and then bonded together.