View Single Post
  #8  
Old 01-08-2013, 12:48 PM
earlyfilm's Avatar
earlyfilm earlyfilm is offline
Eternal Member
 
Join Date: Jun 2011
Location: Culpeper, VA
Posts: 527
Quote:
Originally Posted by Geoff View Post
Well, I think my Bias pot is trashed. It is R7 (3,000 ohm pot, schematic posted in response above).



I then fully disassembled it:



I then cleaned the restive element with non-residue contact cleaner. ff
Geoff,

I don't have a 533, but checked this pot on slightly earlier and slightly later Hickoks.*

I looked at your picture and then at my Hickok 540 (which I don't plan to restore, as I'm not into pre-WWII radios) and my Hickok 600A (which is in line for a restoration by me, as soon as I get some of my other test equipment calibrated) and I don't see the contact slider plate in your second shot.

Is it there? It should be a brass plate with a right angle bend and have a hole the size of your 1/4" shaft on one end and the other end has a hole that the center slider screw fits through. This plate completes the circuit from the slider to the center terminal.

Have you considered the possibility that someone may have disassembled the pot before you and left something out, or put it together out-of-order?

* Hickok timeline:
540 1942-1945 military, civilian 1945 until stock ran out, and usually like mine, wired as a 560.
533 1949-1952
533A 1953-1959
600 1949-1952
600A 1953-1958


Warning on using any conductive grease! If any gets washed on to the resistance element support by cleaner, then you may have just ruined the pot.

James

Last edited by earlyfilm; 01-08-2013 at 01:27 PM. Reason: Added timeline
Reply With Quote