Quote:
Originally Posted by jhalphen
Hi Timmy,
OK, you're going to win!
Be methodical: i use a yellow felt pen to overline on the paper printout the traces already checked.
Saves your memory from remembering "did i already do this one or not"
Especially if interrupted by a phone call/doorbell ring during the process.
Keep a soldering iron handy to reflow any non-perfect - possibly suspicious solder joints at the ends of each PCB trace.
If so, reflow, then check again with the beeper for A-OK continuity.
Hang in there!
Best Regards
jhalphen
Paris/France
|
i did notice that 2 what i think are chip caps off the vert ic have like corrosion and to fix that is very hard because they are hard to hold and maybe this is where the problem is and i dont know if this corrosion could kill the connection but ill have to try and get them off and resolder. there are no caps that leaked near where these 2 @$#%%$%^4 tv,lol,lol... could it be possible that one of these chip caps are bad if its one responsible for the verticle timing. i dont know if smd components chips are known to go bad even if they have many years on them.