View Single Post
  #15  
Old 11-23-2012, 07:10 AM
jhalphen's Avatar
jhalphen jhalphen is offline
VideoKarma Member
 
Join Date: Feb 2007
Location: Paris, France
Posts: 596
Hi Charlie,

About the Pioneer SX-1500 stereo receiver:
All of these 1972 era Pioneer receivers develop a generic fault:
the adjustable resistor to set the output transistors's idle current bias go to dust i.e. the carbon track self destroys over time.

The power amp affected then shows 2 different symptoms:
- excessive output transistor temp can go to 70°-80°C
- totally cold

In spite of the high temp, the output TO-3's aren't destroyed.

I've had the exact same failure on 3 Pioneer stereo receivers.
I therefore replace with CerMet Mil-spec resistors, problem solved (forever).

The culprit is located on the PWR amp board, one per channel.

On the SX-990 there is a second adjustable resistor, drive adjust (from memory). I replace it also with a CerMet.

Just to let you know in the event you want to use the receiver as a daily driver.

To all: If someone needs the Pioneer SX-990 schematics, i scanned them from the original service manual. Give me your Mail by PM.

See the power amp with this post.

Best Regards

jhalphen
Paris/France
Attached Images
File Type: png Pioneer SX-990-50 - Power Amp Unit.png (26.4 KB, 14 views)
Reply With Quote
Audiokarma