View Single Post
  #11  
Old 11-22-2012, 04:59 PM
Charlie's Avatar
Charlie Charlie is offline
On Land
 
Join Date: Aug 2002
Location: Warren, TX
Posts: 2,582
At my parents' house now for Thanksgiving. I figured I would get to play with the CTC-38 while I was here.

Can't really do what I want... I was wanting to vacuum it out. Now that I get a better look in there, I'm finding there's a lot more dirt than i initially thought. I brought the Electrolux with me, but everyone is in here watching Houston & Detroit, so, running the Suck-U-Lux would not be good at the moment. There is so much dust on the chassis that I know it's got to be straining the circuits. I'm surprised I haven't heard any HV discharge. I ran the set for about 10 minutes.

I brought the CRT tester. The red is quite strong, blue just barely into the "good" zone, and green is way into the bad. That test was with it set to 6.3 volts. Bump it up and it gets better, but nothing is even. It is apparent in the picture.... the picture is quite red right now (however I haven't adjusted anything).

I found that the centering rings are just dangling there. It appears that the extra heat from increased tube heater voltage has stressed the plastic device that holds the centering rings in place. So they are just dangling there on the neck.

If the family goes outside for a bit, I will likely get in there real fast and spend some time with the Electrolux.

Years ago, my CM roundie wouldn't produce a picture. The dust was at least a 1/2 inch thick covering everything. I had never seen so much dust on any chassis. After spending 15 minutes in there with the Electrolux and a small brush, the set a pretty decent picture.
__________________
Charlie Trahan


He who dies with the most toys still dies.
Reply With Quote