View Single Post
  #6  
Old 11-14-2012, 11:07 PM
marty59's Avatar
marty59 marty59 is offline
VideoKarma Member
 
Join Date: May 2008
Location: Arlington, Tx
Posts: 915
Quote: "I "assume" if I do not have to put a crt in it purity and convergence should be good...right?

Am I mentally making this too difficult or is color set restoration something I can be talked through.."

First question: No. If your lucky at a minimum the yoke slid back and needs to be moved forward, or it can be too far to begin with. Convergence can change too. Drive voltages, raster size and variances in line voltage from when the set was built/serviced last can all be a factor.

Purity is a piece of cake but pretty much required. Convergence, you can eyeball the static (center) but you'll never be happy until you get a generator and a degausing coil. Howard Sams set up procedures are pretty straightforward.

So no reason banging your head. You've got the aptitude and the basics. Just more to deal with on a color set and remember the one hand rule and take your time. Frustrated or tired? Time to call it a day!
Reply With Quote