View Single Post
  #13  
Old 09-30-2012, 11:42 PM
radiotvnut's Avatar
radiotvnut radiotvnut is offline
VideoKarma Member
 
Join Date: Jul 2007
Location: Meridian, MS
Posts: 6,025
The remove shorts function on my newer tester seems to work the same way as the older ones; so, I'm not as worried about that feature.

My old 465 had three levels of rejuvenation; as I think the 466 does. If you have to rejuvenate a tube, start out at the lowest level. If that does not work and if the tube is otherwise not watchable, move up to the next level. A lot of guys thought along the "more is better" line and they'd start out at the highest setting. This method is very dangerous and is very likely to ruin the CRT. When rejuvenating a tube with one of these testers, hit the button for a split second and release it.

My 470 has remove shorts, clean and balance, and rejuvenate functions. The remove shorts function is for removing K to G1 shorts, the clean/balance function is for use on color tubes where all three guns may check "GOOD"; but, one gun may be low enough to prevent proper tracking with the other two guns. The rejuvenate function is for tubes where one (or more) guns show an emission level that's in the "BAD" range.

Just to be safe, I start out by using the clean/balance feature on tubes that actually check bad. Most of the time, that's all that's needed to bring them back up. If that does not work, I proceed to the more powerful rejuvenate setting. On these testers, you hold the button down, at which time you'll normally see the meter rise. You continue to hold down the button until the meter falls back down. If the meter rises a good bit up the scale and remains there for a few seconds before it falls down; then, the tube will likely rejuvenate well. If the meter barely moves up the scale and then falls back down quickly or if the meter does not move at all; then, the tube either didn't rejuvenate at all or will not likely last long.
Reply With Quote