|
Did a little work the last two nights recapping, this set has a couple really tough spots, I had to snip and wrap rather than removing the leads completely.
I also had to make up a couple High Volt Capacitors, I needed an .018@1000 and an .022@1000, all I had was some .01@1600 so I made up two .020@1600v caps out of them, one is .004 over and one is .002 under but they were 10% caps to start with so I think they'll work.
They were also in a very tight spot under a mounting strip (actually over the strip with the chassis in the normal position) I moved them over (under) the strip and away from a large wirewound resistor also on that strip.
It ain't pretty but then it doesn't show.
I think I've done all the really tough ones so it should get easier from here.
I'm waiting on my Filters to arrive.
|