View Single Post
  #3  
Old 07-17-2012, 11:27 AM
kx250rider's Avatar
kx250rider kx250rider is offline
REAL TVs have TUBES!
 
Join Date: Oct 2005
Location: Los Angeles & Dallas
Posts: 3,239
0.9 is a funny value, as there's no need to be so precise in a fusible resistor off a scan diode like that. My guess is that the heat has changed the colors, and it's a 5.6 @ 2 watts, and is now high. I'd replace it, but be sure the schematic is correct for that set. If you can't verify, and do replace it with what is believed to be correct at 5.6, be sure to measure that line to see that it's not high at the B+ pin of the vertical output IC. Just to mention; the "slow turn-on" usually means a power supply problem, which would also affect the vertical as you're saying. Check the B+ at the B+ pin on the flyback, and if it's low, you may not have a vertical problem after all. Usually the B+ voltage is shown as "+130 or +135" on the board under the flyback, but if not, you can know what the B+ is supposed to be, by which regulator IC is in the set. (STR-30130=130v; STR-30135=135v, etc). If the regulator is another kind which doesn't tell the output voltage, you can look up the IC in the NTE or SK cross reference and it will tell.

Charles
__________________
Collecting & restoring TVs in Los Angeles since age 10
Reply With Quote