Quote:
Originally Posted by Eric H
Got it home and hooked it up.
CRT is fast to come on and very bright, like new I would say.
Sound is great, all the controls work except the Horiz Hold pot, it hits a certain spot and the set dies and smoke starts to come out the vent holes, turn it back and it comes right back on, most likely the pot itself is shorted.
With a DVD hooked up I can't quite get enough range on the Horizontal (without hitting the bad spot) to get a picture, the sound, vertical, Brightness and Gain (i.e. Contrast) work fine.
It should be easy to get this working but I still want to recap it to make it safe to play.
I think I can make some new vent bars with either Plastic or metal and glue them on from the inside, a shot of Gray Wrinkle paint should make it look nearly good as new I hope.
The Chrome is in beautiful shape, no corrosion and only a few little scratches.
I think this set lived it's life in the Mojave Desert and that's why it's so well preserved.
|
In addition to recapping, I'd replace that horizontal hold pot as well. If it has a bad spot that causes the TV to smoke when the wiper hits it, it is definitely defective (shorting a B+ voltage source to ground) and must be replaced to be 100 percent safe. (I don't know why the TV's line fuse or the house fuse, or both, did not blow when the control shorted.) I hooked up an oscilloscope years ago across the contrast control of my Silvertone color TV, which was still working (albeit with a very poor picture) at the time. The high voltage across the control burned a spot on the scope's intensity pot, causing a loud pistol-shot type noise whenever the wiper hit that spot. The scope still worked, but the sound I heard when the wiper crossed the bad spot told me that the power supply was very likely being terribly overloaded. I finally got rid of the scope (and left the TV at the house; long story and OT) when I moved a couple of years later.