View Single Post
  #4  
Old 06-29-2012, 10:48 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
just checked does not seem to have any fuse or breaker in the primary of the power trans, so all you need to set get a digital multimeter set to ohms, connect test leadt to the the plug pronges and see if its open, should be just a few ohms. if you dont have a DMM there are lots of other ways to check for continuity, just a flashlight bulb and some wire are all you really need, you just need to see if its open, then figure out if its the switch, line cord, or interlock connection.

if its open at the end of the plug, check again at the interlock, if still open jump the switch on the back of the volume control (again no power everything is unpluged). if that does not do it then you may have a open connection somewhere in that part of the circuit. I just recently had a TV that had a bad solder joint right at the interlock. wiggling the plug and the connection at the interlock generally show this up. Also line cords often open up right at the plug due to pulling and bending that will break the wires inside the insulation.
Reply With Quote