|
In most cases they didn't use much stain. Radio cabinets from the thirties on used lacquer and where tinting was required they used dyes in the lacquer itself. Especially on trim wood, legs, etc. which were of some common wood like poplar, they used toning lacquers. These are available today in various shades. What happens with these sorts of woods is that they either won't take stain, or take too much and look muddy. Some of that can be avoided by using a lacquer sanding sealer first and then filling the wood grain pores, then sanding lightly, before any staining takes place, the coats of finish lacquer afterwards. The sanding sealer before anything keeps the stain from sinking in too deep, making the desired finish more controllable. That's the way the factory cabinets were made. In the twenties they used shellac, but around 1930 lacquer came into use. They never used varnish and of course not polyurethane which hadn't been developed yet. Neither of the last two finishes will look authentic. The cabinets had to get out of the door fast and look good, and lacquer being fast drying allowed that.
__________________
Reece
Perfection is hard to reach with a screwdriver.
|