View Single Post
  #12  
Old 05-15-2012, 03:04 PM
old_coot88 old_coot88 is offline
VideoKarma Member
 
Join Date: Sep 2009
Posts: 2,654
As a side note, i often ran into an interesting quirk in the tube version of those GE B&W sets. The hor. oscillator would not start because it was supplied from B boost; it simply didn't get enough juice to start without boost being present. So i rigged a diode and a resistor (forget the value of the resistor) between the osc. plate supply and B plus. The osc. would start on B+, and when the boost came up, the diode became reverse-biased and dropped out, thus allowing the osc. run on B boost as designed.

These sets used low (130V) B+, so the H output would not red-plate when drive was absent.

With such low B+, apparently the exceedingly small CRT neck was necessary to allow wide deflection by coupling the yoke windings tighter to the electron beam.
The smallness of the CRT cathode often led to early loss of emission, as another poster noted.

Last edited by old_coot88; 05-15-2012 at 04:22 PM.
Reply With Quote