Thread: Unknown Zenith
View Single Post
  #17  
Old 04-30-2012, 04:45 PM
radiotvnut's Avatar
radiotvnut radiotvnut is offline
VideoKarma Member
 
Join Date: Jul 2007
Location: Meridian, MS
Posts: 6,025
Back in the '90's, I had so many problems with rebuilt modules that it finally got to the point that if I couldn't fix the board myself, it didn't get fixed. It got to the point where the quality went down, while the price went up.

From what I was told at my local parts supplier, the rebuilder does not actually test the modules. They have a pre-determined list of common failure parts that are replaced and the module is then sent back out. If the failure involved the parts that were replaced; then, you are back in business. If the defective part(s) were not on the "replace list"; then, the module would not work. I think I remember PTS claiming that each module/chassis was actually set-tested before it was sent out.

When I first started buying 9-160, 9-181, and 9-186 modules in the early '90's, they were in the $50-$60 range. About 10-12 years ago, they were over $100 (not worth it).

By the '90's, Zenith was using a single board "module" style chassis and the whole chassis could be replaced. It didn't help matters any that it was usually the CRT that was causing the chassis to burn up to begin with.
Reply With Quote