View Single Post
  #14  
Old 04-14-2012, 12:14 AM
Eric H's Avatar
Eric H Eric H is offline
Administrator
 
Join Date: Jun 2002
Location: So. Calif
Posts: 11,565
Fun, fun, fun.

I spent the whole afternoon working on the chassis for this set, I installed a new Thermistor, replaced all the paper caps, checked and replaced any resistors on the PC board that were out of spec, not many were and not by much but I changed them anyway.

I was able to repair the push on/off switch by taking it apart and cleaning and lubing it, don't know how long it'll last but good for now.

As it stands I have no high voltage and the plate of the HO glows red if I leave it running long enough, the Fly looks OK (as Predicta Flys go) I get the 175 volts to pin 4 of the HO tube but I don't get the -45 on pin 5, more like -.5.

I checked for the 175 volts at pin 2 of the Couplate (K6 on the schematic) and pin 6 of the H Osc tube, it's there, the 260 volts going to pin 1 of the couplate is there also but nothing coming out of pin 7.
I don't really understand how that thing works but it looks as if the -45 volts to the HO tube comes from the Couplate, if all the other voltages are correct then is it bad?
Attached Images
File Type: jpg predictahoriz.jpg (55.5 KB, 29 views)
Reply With Quote