View Single Post
  #5  
Old 04-09-2012, 09:41 PM
earlyfilm's Avatar
earlyfilm earlyfilm is offline
Eternal Member
 
Join Date: Jun 2011
Location: Culpeper, VA
Posts: 527
Quote:
Originally Posted by vts1134 View Post
When I replace parts in a set I remove the old part completely and install the new part through and then around the original mounting hole. Most repairs I find in these sets are cut the old part out and solder the new part in next to the old one. Do most of you also run into similar shoddy work when you restore a set?
Not necessarily shoddy work, but they were complying with the law.

Back then one usually had to give an estimate before the set was repaired and if the customer said "no" you had to remove all your new parts and put the originals back in. You could still charge for the labor. This method enabled that.

However, as soon as the customer OKed the repair most shops just stuck the chassis back in the cabinet leaving both parts in, especially if it was a walk-in with the customer standing there with the money in his hand.

James
Reply With Quote
Audiokarma