View Single Post
  #9  
Old 04-05-2012, 10:27 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
not only do I find sloppy work, but really off values in replacement caps. I just went thru a Crosley where a lot of caps had been replaced with what I presume was the wrong values and voltages. the parts were not even j hooked or pigtailed but rather just lay next to the wire and solder flowed. I suppose it works but it does look sloppy. I do use pig tails when working on thing like old coils where I do not want to stress out the coil form with heat or movement, and will sometimes pig tail if I see a really full up tab on a hard to get at tube socket tab. where it gets real ugly is how some electrolytic caps get done, all manner of mounting, from tape to glue to just dangling...
Reply With Quote