Made a bit of progress since the last post, but I moved backwards in the meantime. While I was troubleshooting the vertical problem I turned the set upright and after a couple of snap crackle pops and the high voltage went away. I was perplexed and couldn't tell where the sound came from so I went back to the schematic. I soon realized that I missed four caps that were hiding inside and underneath the high voltage cage. There were two paper and two bumble bee caps hiding from me. After replacing the offending caps the high voltage returned to normal.
I also managed to find the vertical problem. The offending problem was a capacitor lead that was left behind by a previous repair had shifted into a dead short to the pin next to it on the vertical oscillator. It was obscured enough that I didn't spot it when I looked over the set before firing it up the first time. It kind of brings me to this question. When I replace parts in a set I remove the old part completely and install the new part through and then around the original mounting hole. Most repairs I find in these sets are cut the old part out and solder the new part in next to the old one. Do most of you also run into similar shoddy work when you restore a set?
Any way on to where we stand now. I've got a fairly good picture but I've got kind of a wierd problem. With my horizontal running in frequency my picture is not full width, but when I adjust the horizontal out of fequency the picture is full width.
Can any one give me a possible explanation for this one?