View Single Post
  #7  
Old 03-09-2012, 10:04 AM
cliff1050 cliff1050 is offline
VideoKarma Member
 
Join Date: Sep 2009
Posts: 9
B&k 1076

Quote:
Originally Posted by cwmoser View Post
Interesting question.

I have several B&K 1077B's - functionally the same as your 1076. One of mine came with some probes but they were pretty cruddy and I just assumed they were straight through.

I ordered a few of these:
http://www.ebay.com/itm/320848757247...84.m1439.l2649

I have only used my 1077B's to put up a test image. Have not injected signals to debug a circuit yet. But, looking forward to using the 1077B when I get my next TV.

I think other than the Flyback testing that the probes are basically straight through. You *might* need a capacitor between the TV and the B&K test probe for certain uses.

I have the B&K 1076 manual in PDF format if you need it.

There is a book that shows how to use the B&K 1076:
Television Analyzing Simplified - by Milton S. Kiver
I really like this book.

Don't recall anything in the book about the probes. So, your question has piqued my interest too.

Now the "sister" device to these is the B&K 415 Sweep/Marker generator. It has a few probes that are definitely not straight through.

Carl
your test leads are bnc type there is no bnc connecters on the b&k 1076

but thanks anyway for the info like i say any info is helpfull
my b&k has a few tubes that are week i could add a bncconnecter on the back of the unit ive tryed it out the pic was not to clean but i ws testing on a tv that should be scrapped a old 5 in citazin tv i found on the street.
so i need to get the old screw on center pin mic type connecter
so my b&k needs a littlie work on it it has almost all original tubes in it
so it might be a while before i get to it but its doing what its made for so thanks again.
Cliff
Reply With Quote