View Single Post
  #6  
Old 02-22-2012, 05:39 PM
kvflyer kvflyer is offline
VideoKarma Member
 
Join Date: Nov 2006
Location: Fernandina Beach, FL
Posts: 1,132
Quote:
Originally Posted by bandersen View Post
I restored an Admiral set recently that also had good HV when I measured it at the CRT anode, but had a dim picture. Eventually, I tracked the problem down to a 470K resistor in series with the HV lead that had gone bad. I got erratic values when I tried to measure it. It probably had carbon tracks burned through it. Once replaced, I had a nice bright picture.

That resistor is mounted on the 1B3 rectifier tube base as I recall.
Good luck.
Could be a good call Bob. When I did my 26R12, I just went ahead and replaced that resistor because I didn't like the way things looked under the socket. I may have avoided a problem by doing that! Resistors are cheap...
Reply With Quote