View Single Post
  #18  
Old 01-05-2012, 12:37 PM
Phil Nelson's Avatar
Phil Nelson Phil Nelson is offline
VideoKarma Member
 
Join Date: Jan 2006
Posts: 4,030
OK, here is the LV power supply schematic and the remainder of the HV circuitry (my set has two 1B3GT in doubler configuration, not one as shown there).

http://antiqueradio.org/art/Philco49...ySchematic.jpg

The HV secondary is supposed to be 2.5 ohms and I measure 2.6, so that seems OK.

Pulling the caps from the 6BG6 HOT and 1B3GT rectifier, I measure 134.6 ohms on the top half of the flyback primary (should be 240 ohms) and 35.8 ohms on the bottom half (should be 40 ohms). Not so close, but I can reserve judgment for the moment.

Referring to the p-s schematic, I put the scope on two points: the output side of choke L101, which supplies ~160vdc from the 7Z4 LV rectifier, and the output side of choke L100, which supplies ~320vdc from the 5U4G LV rectifier.

The 160vdc supply looks smooth and stable.

The 320vdc supply is jittery, and the jitters change (along with the ticking sound) as you turn the vertical hold control, seen in these two photos:





So, it's sounding plausible that vertical noise is leaking into that 320vdc line. Referring to the sweep schematic, I see that one lead (red) of the vertical output transformer connects to that line. Possibly I could disconnect that lead and then see if the jitters go away . . . .

Phil Nelson
Reply With Quote