View Single Post
  #9  
Old 12-10-2011, 06:54 AM
timmy's Avatar
timmy timmy is offline
VideoKarma Member
 
Join Date: Jan 2011
Location: Delaware ny
Posts: 3,719
well i tried a new damper tube no change and yes it does have a nice picture for the hv to be low, maybe because the crt was replaced in 1980. all the screen controls are in the front and i followed the sams and did the grey set up 3 times.but still to center the picture and to get the correct height and so on these controls are maxed to one side. when i got the set the left side of the screen was not there about 3-4 inches and the height 1-2 inches was off so something is weird here. well motorola was different. i did notice on the yoke about 10 seconds after turning the set on the yoke on the right side had alittle sizzle or static electricty going on but when the hv came up it was gone so i since cleaned that area of the yoke and it dont do that anymore. i thought that may have been an indication of something going on with the yoke. cap in the yoke,ringing, i thought that also,hmmm.... but those lines concentrated to just that side only starting and the bottom. useing the bar gen that left side is wavy and wont converge correctly. crosshatch pattern lines on that side are distorted.

Last edited by timmy; 12-10-2011 at 07:01 AM.
Reply With Quote