View Single Post
  #15  
Old 11-26-2011, 03:00 AM
Electronic M's Avatar
Electronic M Electronic M is offline
M is for Memory
 
Join Date: Jan 2011
Location: Pewaukee/Delafield Wi
Posts: 15,496
The resistor that comes off of the focus pot and goes to ground is an old school 2 watt carbon comp resistor and that was the factory component. My only meg ohm rated replacements are also old school 2 watt carbon comp units that are of unknown vintage and manufactuer so I can't realistically check the speck sheets. The 6.8 meg unit that failed was a 1 watt unit, and I should have stuck with 2 watt, that is where I was dumb. My best solution presently is to use some 2 watters and some 1 watters. With the 1 watters being of equal value in parallel with each other so to divide the current equally among the two and make a pair of 1 watters behave as a two watter.

Right now with the focus control maxed out I've got 4KV and almost good enough focus. I'm going to add one more resistor so the best point will be in the controls range and do my best to make it fit the HV cage safely. I have just enough resistors to pull off this jury rig.

This will be a "till we meet again" kludge repair which I anticipate will last between two weeks and two years based on the sets track record. I WILL track down a new divider as soon as I finish my kludge and have it ready to drop in before the next failure, god willing.

I suspected that the divider was slowly going bad, but I could not prove it, and what is more I did not think that replcements were obtainable untill reciently. So now that I believe that I can get a new divider I will track one down, and install it the next chance I get after the next time it starts to act up.

I'll elaborate on what I've done soon.
__________________
Tom C.

Zenith: The quality stays in EVEN after the name falls off!
What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4
Reply With Quote
Audiokarma