|
well those were all in the vert and since I was having some issues with the vert hold range I figured may as well start there. No reason to chase down pairing until I get the vert range worked out.
Oh and I did try subbing some vert tubes, I know that multivibrators are by there nature are unstable and different tubes behave differently.
I checked the .0082 cap that was the one of the plate, again almost no movement on the cap tester. Replaced it, did check the replacement going in, just to be sure it was not the cap tester, worked as should. I do test the caps completely out of the circuit as sometimes the cap tester gives false readings, even if one leg is completely out of circuit. while I am in there I am replacing any resistors that would be hard to get at with the cap in place there is one that sits right under the .0082. its 100k tested at 93k so normally I would leave it be, but since I would have to remove the cap just to get at it later, I figured what not replace know.
|