Ok I found where the last wire goes to terminal strip near the E-cap #2
to the rear of #1..double checked my connections by doing one wire at a time by color code and tracer...I
Did clip back a 1/4"inch from the solder terminal.
leaving a tiny bit of original insulation with the color code removing the old tranny..
one Brn/Blk to ground
Red/Grn to CRT and other filaments.
one Grn/REd to the "TOPHAT"diodes;one REd to the bottom of fuseholder
Brown to one side of the fusible link #26 wire;Black to terminal lug..solid green
to filaments..trying too remember the connection of the White/Black tracer goes too
?..