Quote:
Originally Posted by stusnyder
Dug this chassis out last night, it has been totally recapped, some resistors replaced. It has a raster, but no picture. I used a B&K television analyst and injected video at the v14 video amp tube. I got no test pattern but I did get some kind of signal thru, because the rastor changed state. Any suggestions where to look next?? This is one set I'd really like to get finished.
|
Try injecting a signal at the picture tube where the video amplifier connects. If you get a picture then the trouble is in the video output circuit. It should not be too difficult to isolate provided you are injecting the right kind of signal. That is pure video, not RF.