View Single Post
  #22  
Old 11-11-2011, 02:20 PM
wa2ise's Avatar
wa2ise wa2ise is offline
VideoKarma Member
 
Join Date: Dec 2002
Location: USA
Posts: 3,147
Quote:
Originally Posted by VintagePC View Post
If memory serves, you can easily run 50Hz equipment on 60Hz. The problems occur when you try to do it the other way around ....
To a first order approximation, the higher the frequency the smaller and less turns you need for the primary and secondaries for the same voltage. A 50Hz transformer running at 60Hz can take a higher input voltage before its core saturates, roughly 6/5 higher. But a 60Hz transforemr run at 50Hz can take only 5/6 the input voltage, unless it was overdesigned with enough margin to avoid care saturation. Sometimes you find a power transformer made for 25Hz, it can take 12/5 higher input voltage (assuming the insulation inside it can take it, especially the B+ windings). But if you do that, all the secondaries will have proportionally higher voltages too. Sometimes you find mil surplus equipment that was used in airplanes, and airplanes used 400Hz, speciffically to keep the weight down. You cannot use those power transformers on regular 60Hz, unless you only apply about 18V to the 120V@400Hz primary. 60/400 And the secondaries will also deliver only 6/40 as much voltage, not too terribly useful...
__________________
Reply With Quote