View Single Post
  #6  
Old 10-22-2011, 09:01 PM
mbates14 mbates14 is offline
VideoKarma Member
 
Join Date: Apr 2004
Posts: 1,016
ya i can fix those light of death issues, i know what causes it. noise in the power circuits going through all the logic.

If you replace just the caps on all the SMD regulators, and the obvious 1000uf ones, (the regulator caps are 220uf, 100uf and 47uf), it takes care of the BGLOD. the 47UF caps that surround the 5v, 3.3v, and the 2 1.8v regulators on the formatter cause BGLOD. the 100uf, 47uf, and 220uf caps that are on the DM module surrounding the same regulators cause the rainbow/lines.

If not, rig a switch on the FC connector on the formatter PWB. thats what i did for awhile until i broke down and recapped it.

You cut the power to the formatter logic, wait for DM to boot, and flip the switch back on to boot the formatter, then power TV on. works.

My issue now, is i lost sound. probably a solder blob or one of my new caps is actually bad. I was tracing through the schematic, they seem to be I2S system for sound, which is what CD players use. The I2S gets built inside the signal board (which is the board i did NOT touch). Then its passed over to the DM modules main CPU, which then gets sent into a switching logic that switches between the MP3 IC and the main sound.

It then moves from there to the CS42XX DAC, and the analog signal gets sent from there to a DSP which does your volume, treble, bass, EQ, etc....

Then from there, back to the signal board to get amplified. So somewhere in that mess of logic, im loosing the signal. Like i said when i crank up the volume all the way, i hear alot more hiss if i put my ear to the speaker. So that means the DSP is functioning and has serial control from the micro, so im either missing the I2S signal, or the DAC died. What sucks is you cant signal trace shit when the set is running, because its all gotta be sandwiched together, so im probably going to have to solder wires at random spots and run them outside of that mess of a chassis.

The TV does have a card reader, so i could use an SD card with MP3 files, because i know if i get sound that way, im missing the I2S from the signal board, if not, the DAC is dead. There is an ST013 MP3 decoder on the DM board, and the switching logic will switch between the main sound I2S comming from the signal board, or the ST013 MP3 I2S audio. That would be a good first step i guess.

I would scope the I2S buss coming from the signal board, and the analog audio out from the DAC going to the DSP, but.... chicken and the egg syndrome. LOL

Last edited by mbates14; 10-22-2011 at 09:17 PM.
Reply With Quote