|
I'm going to do some calculations later to see if the replacement I have is workable (I will want to fix my set fast once I have it down as it takes up a ton of realestate in my cramped bed room/work shop/collection display-store room (if I took out my 6 TV consoles and 3 radio consoles it would be very large).
The short in the B+ was through the pin-cushion transformer (if memory serves) to a terminal then through a carelessly dripped blob of solder to ground. The short made the old power resistor smoke, open, and crumble. And what is more before I realized there was a short I put a dale type in place of the origional power resistor and it exploded! That can not possibly be good for the pincushion coil....
I wonder if the reduced width was related to either the pin-cushion coil, or my desoldering and resoldering of the components (at least one resistor had bubling wax on it's case from the heat, and the ceramic around the leads crumbled on a couple of the ceramic caps) on the output tube that led me to find the dead B+ lines.
Gota run.
|