View Single Post
  #30  
Old 10-08-2011, 01:30 AM
Mr Hoover's Avatar
Mr Hoover Mr Hoover is offline
VideoKarma Member
 
Join Date: Feb 2008
Posts: 65
Hi

There isn't any AGC on this TV I think,that's why it has this gain control and is critical in adjustment.The Philco Safari is the same,though has a 3 position sensitivity control,it seemd only the "second genration" transistor sets had something as exotic as AGC.

"Contrast" is preset on the middle board with that little control,so sort of set that for best looking picture when happy with the gain setting...yes this set is a weirdo!!!

The gain control is a dual ganged pot,one part attenuating the antenna signal and the
other the IF gain.I found it was better connecting the antenna in at full gain all the time
into the tuner,or one could end up with a slightly grainy pic but the IF gain about right,just resolder the coax inner going to the tuner to the top end of the pot where the signal is coming in via the same thin coax.

Try running the TV from a 12 volt supply if you can and see if the hum goes
and what happens to the picture bending effect on the right side.If you haven't the right DC sony connector brown wires in the TV are the 12 volt line I'm fairly sure.

Around the sync separator stage there's a 100K resistor which wasn't fitted on the pcb
on one of mine,holes there but never been soldered in...fitting that cured sync problems that set had.

You're getting there...

Hugh

Last edited by Mr Hoover; 10-08-2011 at 06:55 AM.
Reply With Quote
Audiokarma