View Single Post
  #25  
Old 10-07-2011, 08:45 AM
Phil Nelson's Avatar
Phil Nelson Phil Nelson is offline
VideoKarma Member
 
Join Date: Jan 2006
Posts: 4,030
Yah, the horizontal linearity is currently stretched somewhat on both margins, not on one side alone as I often see in older sets. The manual doesn't say a lot about horizontal adjustments, just telling you to use the stabilizer slug and frequency control to achieve lock, and then:

"Adjust Horizontal Drive control for best linearity. Repeat adjustments if necessary."

When I was fooling around with adjusters before reading that part, I found the Drive control and tried using it in the customary way, adjusting until you see a light drive line and then backing off a little. A drive line never appeared, but I noticed that the Drive control changed horizontal centering, so I centered the picture for the time being and left it at that.

I will check the temperature on the 2SC41 transistor as you suggest. I can also check its voltages shown on the schematic if that section is accessible when the center board is removed. I'm curious about that whole board-pulling scheme. If you really can power up the TV with one board or the other pulled out, that would be good to know for future reference.

Phil Nelson
Reply With Quote
Audiokarma