Quote:
Originally Posted by drh4683
The space command motor shaft is supposed to be set far back (unmeshed) from the drive gear when not in operation. When the motor is actuated, the shaft is pulled forward like a solenoid and it meshes to the driven gear. Make sure that the motor shaft floats up and down freely. Those often can be stickey and will not turn, or not float leading to a non-functioning drive motor. Does the motor run when you press the channel indicator buttons on the front of the set? If not, definitly have a seized motor due to dried out/sticky grease which 9 times out of 10 they are stuck when they sit idle for 20+ years. A little bit of 3 in one oil on the front and rear motor bushing while pressing the shaft back and fourth a few times will free it up. The shaft is springloaded so it should return to its natural (disengaged) position without binding.
The channel indicator bulb is special on these sets. Since you had the tuner out, you probably saw that the lamp shines through a channel number wheel on the tuner. The focused light through that wheel is projected forward and is displayed on a special matte finish lens on the control panel. It looks like an ordinary #47 bulb but its not. You need a #239 miniature lamp which has a special filament and envelope to focus the beam. Use of any other bulb will make focusing the channel number on the display impossible.
|
Yes, the motor must be seized. It won't budge.
Thank you so much for the tips, I'll get that sucker working. I will order a bulb next week!
MK