|
Hi Jordan, if by the end pins you mean the two that are off by themselves at each end of the row of display pins then I'm getting basically no voltage, AC or DC.
Using a shield on the Mainboard for a ground I can find 5.0 volts at several locations on the various connectors that go to the board FP-746 but no -5.0v, I can't check pin 53 of the IC because it's just too small for me to work with, I'd blow it up for sure if I tried.
The highest voltage I find going to any of the connectors on the board 746, is -16v measured from the grounded shield on the Mainboard.
|