View Single Post
  #2  
Old 08-27-2011, 03:36 PM
jpdylon's Avatar
jpdylon jpdylon is offline
<-- sucker for old sets.
 
Join Date: Apr 2005
Location: Knox County, Tennessee
Posts: 1,675
Look on the FP-746 "mode control" board

You should have heater voltage (between 2-4v outer pins -ac or dc on the flourescan) and a negative voltage around -30vdc to drive the grid (check pin53 on IC 102). Often times the grid voltage goes missing due to a failure in the regulated supply or IC.

Also check to see that you're getting +5 and -5v regulated, and that the 8mhz clock is running on the display processor (pin 5,6 IC102). Otherwise the display mode controller won't work and you'll get no display either.

Machine works otherwise?
__________________
Jordan
Reply With Quote