View Single Post
  #4  
Old 08-24-2011, 09:47 PM
Robert Grant's Avatar
Robert Grant Robert Grant is offline
VideoKarma Member
 
Join Date: Feb 2008
Location: Monroe County, MI
Posts: 518
Smile So I foundie my roundie! :-) Now What......?

Well, we brought the set here from Yale this past Sunday. Incredibly, it fit in the Prius (with the rear cap snugly at the top of the rear hatch window!).

The set is a Zenith 5317U, Chassis 24MC32 (I had been looking for a roundie for some time, as, when I was very young, our house had only B&W and my grandparents' RCA CTC-16 fascinated me).

I had to take a gamble, as I don't have a CRT tester, and the one other part I really wanted to look at - the flyback - appears to be in a box with no opening, and, in turn, behind another enclosure.

As can be seen in picture 8, the CRT is a rebuild. The owner (who was honest about the TV being not working from the get-go and was very kind to help us pack the set) said that the CRT had been replaced twice, so I am optimistic about the 21FJP22A, as it has likely had few hours on it.

The cabinet is in good shape for the age of the set, with the only significant scratches at the lower right of the front (I wonder if, and how, I should dye the scratches in the wood, but I won't worry about that until after I watch "Get Smart" on it).

I was surprised that the set is full of compactrons (being a roundie), this is disappointing, as my old Heathkit tube checker can't test them.

The IF strip is 6BZ6=>6BZ6=>6EJ7, so I guess this is the "later" 24MC32 (talked about this on another thread earlier).

Since the owner had already powered it up recently (a no-no, of course), we plugged it in, and all three filaments in the 21FJ and every chassis tube in sight - except the focus rectifier - lit up. At first, there was no other "sign of life" from the set, then I remembered the circuit breaker button, and the set gradually came up with the strange off-center blob in picture 9 (implicit in this is something must have overloaded the B+ supply once in the past to trip it). Later, I discovered the service switch was in set-up, and switching it to norm brought up a full screen of gray, too blurred for snow, and a pastel rainbow at the right as in picture 10 (without the bar near the bottom - that is only a digital camera artifact). The good news is that the CRT did light up white/gray and nothing popped or zapped.

The tubes have little white specks on their exterior, as in picture 5. I don't know what causes this, and I've seen it before (I suspect it will not affect the operation of the set at all). Picture 6 shows the high-voltage district, seemingly inaccessible, while picture 7 shows the yoke and static-convergence assembly seem intact (but what is that string that looks like fishing line around the neck?).

So, I'm asking for recommendations on how best to start the restoration project (the obvious first would be to check under the chassis for burnouts and replace the LV power supply caps). I want this baby to roll!
Attached Images
File Type: jpg IMG_0108.jpg (53.1 KB, 99 views)
File Type: jpg IMG_0109.jpg (75.9 KB, 47 views)
File Type: jpg IMG_0110.jpg (63.2 KB, 48 views)
File Type: jpg IMG_0114.jpg (75.6 KB, 47 views)
File Type: jpg IMG_0115.jpg (61.5 KB, 77 views)
File Type: jpg IMG_0116.jpg (105.2 KB, 86 views)
Reply With Quote