|
No more tilt!
I ended up using the specified value of resistor in the AGC circuit. After jumping in the various values the 3.3M worked best overall. As I mentioned, this set had a 2.7M in place and it looked like it was there from day one. However, with that value if I adjusted the AGC pot it would drive into a good overload at one end but decresed to the other. With the 3.3 in place the overall range was more normal to me with nothing extreme. With using convertor boxes etc. and overloading and audio buzz issues being more common to deal with the last thing I'd want is too much gain. And yea, with a lot of text on the screen the audio will buzz some and I'll try to minimize some of that later. It does have good, clean audio output for normal listening as well as video.
Loosening the yoke worked out quite well. After getting the chassis out of the way and the tension springs I sat it down on it's face and the yoke stayed as stuck as ever. So, first step was to see if I could manipulate any movements. First, I carefully pried with my fingers the windings that were against the bell of the CRT and after awhile that proved to be working. I kept doing this until I was able to detect movement by some twisting action.
Eventually, it was coming loose with one set of windings and not the other. This yoke is on the brittle side so I made sure to grasp it at it's absolute front. Slowly but surely at it became looser and looser until it finally came undone! The key here was to not force it to move any more than it wanted to and it did take a while to break free but with positive results!
Once I was able to slide the yoke back you can see why it was stuck so well. I'm not sure if that was double stick tape used to adhere the yoke to the CRT but the tape stayed stuck to the windings which I left in place. I cleaned the CRT bell with some handy lacquer thinner to get off the residue and reassembled everything. The yoke cover is distorted from the centering tab/spring plate but it's not breaking apart so I left that alone too. As assembled, the yoke can be centered with little effort and stay in place. Now I can deal with the cosmedics!
|