|
Just to throw an oddball out there for you guys, I have repaired a couple of these same dells with a newer-style power supply, same monitor though. Had better capacitors.
However, the CCFLs have failed. Usually can spot those by hearing a bad hiss from the inverter and instant shutdown (with good caps).
swapping the CCFLs with new ones worked like a charm. just worked a deal out with a chinese supplier, as i needed 8 of them and at $7 bucks a peice that gets expensive. I will say that disassembling the panel is a royal pain in the ass syndrome.
I have done some other weird things, like bolting a 37" toshiba chassis that had a broken screen, onto a scrap but good 42" Olevia-LG LCD panel, Both had the same LVDS connection. and built a wooden frame. It worked. LOL makes a good shop TV/monitor, only thing I had to do was some rewiring for the inverters, as i used the original inverters on the Olevia panel. The PWM/enable signals come through the T-con on the Olevia panel, They came straight from the signal board on the original toshiba setup. and surprisingly the firmware knew how to autosense and control it via the T-con.
all i did was rewire the power supply connection wires to fit the toshiba power supply.
Usually, if the programmers are smart, they take advantage of the ID code stored into the panel's T-con module. When requested, the panel replies with an ID code that contains the panel type, resolution, etc... and better written firmware will auto sense and switch modes to support the connected panel. Laptops do this, the video BIOS knows how to handle that.
Toshiba chassis did, philips you have to modify the option codes in system service menu.
Last edited by mbates14; 08-10-2011 at 11:25 PM.
|