So close yet so far.
At the end there was a CD sized spot that had wet looking fingers around it like on RCA tubes, that went away when it cooled off (which was before I took the picture).
I burned through ALL 6 of the strings. Some failed quickly. All snapped within 2.5" of the handles. It is bothersome that towards the inside of the cateract the glue seems to dissapate too much of the heat to melt very well, while towards the edges and exposed parts of the wire the wire blackens/burns becomes brittle and weak and snaps a bit too easily.
Part of the reason for the lop sided removal was the glue not melting right at the beginning, the other part was that rocks were some how finding their way from the parking lot to the edge of the glue. Most rocks did not make it any further, but one or more did as you can see below.
Another problem that arose near the end as the shade invaded my work area was that the screws on one paddle pulled out and I tried to do without which cost me some usable wire.
A strange air pocket also formed, and can be seen above the large glare spot.
I will NOT be able to do more for about the next week which makes how close I came to getting it off without sucess all the more frusterating!
When I do get the safety glass off, what should I use to clean the glue?
Tom C.