Thread: Capehart 661-P
View Single Post
  #96  
Old 07-22-2011, 01:10 PM
old_coot88 old_coot88 is offline
VideoKarma Member
 
Join Date: Sep 2009
Posts: 2,654
Quote:
Originally Posted by Phil Nelson View Post
...The height is about right, but I can't bring in the width any narrower, suggesting (along with other symptoms) that the HV is insufficient. The designers may have planned for some horizontal overscan, but this amount would cut off way too much behind the mask.
In later years, mfrs sometimes used a "width sleeve" to reduce width without affecting the HV. It was a sheet of very thin brass rolled into a cylinder and slid partway into the yoke. The shielding effect reduced the H sweep much moreso than the vertical (if at all), probably due to hysteresis differences between the H and V frequencies.

I don't know if this'd be doable in your situation, or if there's enough clearance between the CRT neck and the yoke for the brass sleeve AND an insulating layer to prevent any arcing issues. Just a thought anyhow. oc
Reply With Quote