|
OK, I fixed the problem. It turned out to be a bad 1000 uf cap in the flyback supplied 29 volt supply to the vertical output stage. I'd already checked the voltage; but, I failed to check for excessive ripple with an oscilloscope. Once I noticed a bunch of trash on the 29 volt line, I tested the cap and it measured 380 uf, instead of it's rated 1000 uf. Now, I have a filled out raster; but, there are now intermittent horizontal streaks at the top and bottom of the screen that bounce around. Hopefully, it will be caused by bad solder connections.
The lesson here is to always check all power supply sources for proper voltage and excessive ripple before digging into a circuit. I already knew this; but, this was one of those times where I decided to skip a step and it ended up taking me longer to find the problem.
|