View Single Post
  #72  
Old 06-29-2011, 01:30 PM
bandersen's Avatar
bandersen bandersen is offline
RCA 741PCS
 
Join Date: Mar 2009
Location: Chicago, IL
Posts: 8,829
Quote:
Originally Posted by toober View Post
If you ever need to reproduce more of that zig zag veneer (or any complex cutout veneer), here is a good trick:

Cut a veneer strip a little longer than the size you need, without all the zig zags and cutouts. Clamp this strip between two nice stiff hunks of similar wood, then run the whole thing slowly through a table saw with a sharp dado blade, cutting out the pattern with as many passes as you need. Unclamp, and find a perfectly shaped piece of veneer within. You can even do multiple strips at once. You can also do this trick with a router table.

--
Will
Thanks for the tip!

I did a little test with the grain filler before moving on to the real cabinet.

A glued a scrap of mahogany veneer to a board and stained it.


I wonder how long this can had been sitting around ? It took about 20 minutes to get a smooth consistency.


I mixed a little with some mineral spirits as indicated on the can and applied a thick coat. Probably a little too thick.


Once it dried to a haze, I wiped off the excess with burlap going against the grain.


Finally, 3 coats of Deft sanding sealer, a little sanding with 400 grit and 3 coats of Deft gloss.

After the lacquer cures, I'll rub out the finish with pumice and rottenstone.


Now onto the real thing.
__________________
Here are my Vintage Radio & TV YouTube Channel and Photo Gallery

Last edited by bandersen; 06-29-2011 at 10:48 PM.
Reply With Quote