|
Damen wonders >>> I . . . was disappointed to see a brightener hanging off the the 1970 RCA Colorama picture tube . . . the tube . . . tested good . . . I . . don't know why someone put a brightener on a good tube <<<
Well first, one needs to stop thinking "today" and put one's self in a "1960's frame of mind."
>>> it came from a little farm house way out in the country down a old dirt road built in 1916 <<<
I don't know about Oregon, but in western Tennessee, those farm roads were wired for pre-WWII loads. When air conditioners became affordable for home use in the rural areas, it was not uncommon to find line voltage at 90 volts during the heat of the day and at 130 early in the morning.
The voltage problem was so bad that the shop that I worked for would recommend against buying a color set if you were on a rural line. We actually installed variacs with a voltmeters on some of the B&W sets to keep them from being fried.
A probable scenario:
Low line voltage caused the horizontal and vertical sweep to pull in, and the resulting high voltage drop caused the image to bloom thus filling out the sides. This caused a not-too-sharp service man to diagnose a bad CRT, instead of low voltage, but it did improve the low brightness.
James.
Last edited by earlyfilm; 06-24-2011 at 11:29 AM.
Reason: clearer wording
|